Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

1841 router vlan vtp problems

Hi everyone

I have a 1841 router with a 1 adsl wic and 1 4esw wic

here is my problem:-

I have configured the router with the relevant vlan interfaces

for 3 vlans

interface Vlan1

ip address 10.1.0.1 255.255.255.0

no ip redirects

ip nat inside

ip virtual-reassembly

!

interface Vlan2

ip address 10.2.0.1 255.255.255.0

no ip redirects

ip nat inside

ip virtual-reassembly

!

interface Vlan3

ip address 10.3.0.1 255.255.255.0

no ip redirects

ip nat inside

ip virtual-reassembly

the 1841 is the vtp server for the domain, and the links are trunking through the 4esw wic,

however when I created a new vlan vtp isn't being updated.

I have to go to the vlan database and created the vlan before vtp updates, from my other routers ie 877 etc when ever I create a vlan vtp is updated accordingly,

I hope this makes sense, this is really annoying me and i'm wondering if anyone else has had the same problem, if so would you mind letting me know how you overcome it.

Thanks in advance.

3 REPLIES
Cisco Employee

Re: 1841 router vlan vtp problems

Hi,

Please provide 'show vtp status' from 1841 and any other router in the same vtp domain. Is 1841 the only vtp server or are there any other vtp servers as well in the domain.

-Vaibhav

New Member

Re: 1841 router vlan vtp problems

hi thanks for your reply

there is only one vtp server and the cisco 1841 router is the vtp domain server the other devices are cisco 3750 switches.

as requested here is the info

ROUTER# sh vtp status

VTP Version : 2

Configuration Revision : 17

Maximum VLANs supported locally : 19

Number of existing VLANs : 6

VTP Operating Mode : Server

VTP Domain Name : domain-vtp

VTP Pruning Mode : Enabled

VTP V2 Mode : Enabled

VTP Traps Generation : Disabled

MD5 digest : 0x2A 0x25 0xCE 0x90 0xD3 0x53 0x15 0xF6

Configuration last modified by 10.1.0.1 at 2-18-08 08:58:52

Local updater ID is 10.1.0.1 on interface Vl1 (lowest numbered VLAN interface found)

If there is anything else you need please let me know.

New Member

Re: 1841 router vlan vtp problems

I have managed to work it out,

the vlan database is still updated from conf t

mode, using the vlan command ie

router(config)# vlan 10

router(config-vlan)# name vlan010

this command updated the vtp database,

which i have confirmed works do checking sh vtp status

and the revision increments each time i make a change,

I just wasn't aware of the vlan command in config mode,

I was also able to show the vlan's with the sh vlan-switch command

my problems have now been resolved, and I have shared my solution with you all.

thanks again for all the input.

1541
Views
0
Helpful
3
Replies
CreatePlease to create content