Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

1841 split

I have a LAN of 48 pc's. The ip's starting from 192.168.0.101 till 192.168.0.148. I also have a 1841 router with 2 ADSL connects and I would like the odd computers to be provited internet through the 1st ADSL and the even computers through the 2nd ADSL.

Can you help me please wiyh config?

Thank you.

1 ACCEPTED SOLUTION

Accepted Solutions
Purple

Re: 1841 split

The config will be exactly the same except that you have to replace the atm0/1 and atm0/2 interfaces that I used as an example with the actual interfaces. Therefore, if you need to use a dialer interface, you will need to use those as the next-hops.

Paresh

3 REPLIES
Purple

Re: 1841 split

Hi,

You need policy routing to accomplish this.

Try something like the following:

interface FastEthernet0/0

ip address 192.168.0.1 255.255.255.0

ip policy route-map PolRouteMap

!

! ACL for odd IPs

access-list 10 permit 192.168.0.1 0.0.0.254

! ACL for even IPs

access-list 20 permit 192.168.0.0 0.0.0.254

interface atm0/1

ip address .....

!

interace atm0/2

ip address..

!

! send packets matching ACL 10 out atm0/1

route-map PolRouteMap permit 10

match ip address 10

set interface atm0/1

!

! send packets matching ACL 20 out atm0/2

route-map PolRouteMap permit 20

match ip address 20

set interface atm0/2

Hope that helps - pls do rate the post if it does.

Paresh

New Member

Re: 1841 split

Thank you for your reply.

For example if i have 4 pc's:

192.168.0.1

192.168.0.2

192.168.0.3

192.168.0.4

and i d like 0.1 and 0.3 goes internet from first dsl connection and 0.2. and 0.4 goes internet from the the second how we ll be the config?

I ll not setup dialers for atm0 and atm1?

Thank you.

Purple

Re: 1841 split

The config will be exactly the same except that you have to replace the atm0/1 and atm0/2 interfaces that I used as an example with the actual interfaces. Therefore, if you need to use a dialer interface, you will need to use those as the next-hops.

Paresh

113
Views
5
Helpful
3
Replies
CreatePlease to create content