04-12-2010 10:51 PM - edited 03-04-2019 08:07 AM
Dear All,
I just need to confirm that either 1861 CME routers support switchport port-security .... commands are available???
If yes then on which IOS and if not then what is the alternate to fix the port security on the 8-port ethernet card?
thanks,
04-12-2010 10:57 PM
3-port ethernet card??? I've never heard of one. Can you provide the model number of this card?
04-12-2010 11:00 PM
sorry. typo mistake,,, it is 8-port ethernet card !!!
thanks
04-12-2010 11:07 PM
8-port switch on an 1800 ISR G1? You mean the NME-XD-48ES-2S-P?
IF so, then it won't work because this is supported starting from the 2800 router.
Cisco EtherSwitch Service Modules for Cisco Integrated Services Routers
http://www.cisco.com/en/US/prod/collateral/routers/ps5855/product_data_sheet0900aecd8028d15f.html
04-12-2010 11:13 PM
then please tell me how I can configure switchport security on 1861 ethernet port???
04-13-2010 03:19 PM
If indeed you are using the module, it's not the question of you can or can't configure. It's a question of whether or not the module is even supported on the 1800 router.
04-13-2010 09:45 PM
The 8-port ethernet module is supported in 1861 routers.
04-13-2010 09:48 PM
What is the complete model number of the module?
04-13-2010 10:45 PM
Dear Friend,
The module is built-in / fix in the 1861 router.
Ref: http://www.cisco.com/en/US/products/ps8321/index.html
Thanks,
Aman
04-13-2010 11:08 PM
Oh nuts. I forgot about this model.
Port security should be supported. Can you post your config and what you are trying to do?
04-13-2010 11:30 PM
Dear Friend,
I am trying to put the command in the interface mode...
switchport port-security .....
but this command is not available in this router.... do I need to configure it some other way or need ot upgarde the IOS... If the IOS then which IOS???
Thanks,
Aman
04-14-2010 02:19 AM
Are you entering the command on the LAN ports or the WAN ports?
04-14-2010 03:23 AM
Friend,
I am configuring switchport security on the LAN interfaces, IP phones are terminating on these ports directly......
04-14-2010 06:10 AM
Hi,
Would you please share the output of sh ver
Shailesh
04-14-2010 02:05 PM
Here is how it is configured,
It will not shut down the port, but prevents traffic other than what is specified from passing:
mac-address-table secure 0007.0002.0006 FastEthernet0/1/1 vlan 7
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: