I am having 1G-SFP compatability issue with the SUP7E on 4510R+E
The chassis is on cat4500e-universalk9.SPA.03.02.03.SG.150-2.SG3.bin with entservices license.
I tried two scenarios
1. A 3560E with GLC-LH-SM is directly connected to the SUP7E port1 with 1000baseLX SFP's. The link does not come up. The "show int ten5/1" output shows that the sfp has been detected. However if i put the 1000baseLX on a second 3560 and connect to the first 3560, the link comes up fine,
2. Did the same with a pair of 1000baseSX transceivers. the result is the same.
The datasheet sheet says that the SFP is supported.is there something that i am missing, Also tried if any options are available in the hw-module command, I dont see any int gig5/X on the chassis,
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...