Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1T3/E3

I have a 1t3/e3 card in a new 2951. When I statred the router, I found no interface corresponding to this module when do "show ip interface brief"

any idea?

thanks,

Han

2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Bronze

1T3/E3

If you issue show version, do you see the T3/E3 listed?

You need to configure the card type for the interface to appear.

Please refer to the documentation:

http://www.cisco.com/en/US/docs/ios-xml/ios/interface/configuration/12-4/ir-t3e3-csu-dsu.html

Hall of Fame Super Silver

1T3/E3

Han

With many of the new cards that can do both T3 and E3 they need a configuration command to tell them which way they should function. I would guess this is the case with your card. Try using the card type command and tell it whether it is to do T3 or E3. That will probably create the appropriate controller(s). And when you configure the controller with channel-group (or whatever is appropriate in your environment) then there should be serial interfaces to configure.

Give it a try and let us know the results.

HTH

Rick

3 REPLIES
Silver

1T3/E3

what is the output of show diag

Hall of Fame Super Silver

1T3/E3

Han

With many of the new cards that can do both T3 and E3 they need a configuration command to tell them which way they should function. I would guess this is the case with your card. Try using the card type command and tell it whether it is to do T3 or E3. That will probably create the appropriate controller(s). And when you configure the controller with channel-group (or whatever is appropriate in your environment) then there should be serial interfaces to configure.

Give it a try and let us know the results.

HTH

Rick

Hall of Fame Super Bronze

1T3/E3

If you issue show version, do you see the T3/E3 listed?

You need to configure the card type for the interface to appear.

Please refer to the documentation:

http://www.cisco.com/en/US/docs/ios-xml/ios/interface/configuration/12-4/ir-t3e3-csu-dsu.html

203
Views
0
Helpful
3
Replies