I have (2) external IP ranges I'd like to assign to a multilink frame relay interface, both of which are controlled by the same ISP. The frame relay is bundling (3) T1s into a 3xT1 running on a Cisco 2821 with IOS Version 12.4(25).
I successfully have the following config running, except for sub-int .501 which I will be adding once the routing is changed with the ISP for the additional range.
1. Will the below config function correctly since the DLCI is being duplicated on the subinterfaces?
2. Will I need an additional DLCI even though it's probably connecting to the same DCE frame-relay switch?
Let me know if there is a better configuration for this setup.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...