Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2 way nating on a 2621

Giday....we have 2 nets, net a and untrusted net b, currently we have one way nating from net b to net a translating to one net a address.

We now have a requirement for some net a addresses to send traffic to around 10 static addresses on net b.

This net a traffic will be sent over 2-3 well known ports ,any suggestions???

confg-->snip

!

interface f0/0 (net a)

ip nat outside

!

interface f0/1 (net b)

ip nat inside

!

ip nat inside source list 1 interface FastEthernet0/0 overload

ip nat outside source list 10 interface FastEthernet0/1

Regards

kellym

1 REPLY
New Member

Re: 2 way nating on a 2621

Hi

You can do static nat for 10 specified addresses from b to a then you have your connectivity when send traffic from outside to (NET A address which you assigned to NET B address).

Regards

Bahman

93
Views
0
Helpful
1
Replies