Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2511 Remote access to additional routers via asynchronous lines

Currently looking to configure a 2511 that is behind an ASA5520 (setup on a DMZ), to allow the use of its asynchronous lines for use as console or aux connections on other 2500 and 2600 series routers. The aim of the project is to allow a console connection from the outside world through the 2511 via one of the asynchronous lines. If anyone has used an asynchronous port as a connection for a console or aux link to another router for this purpose, I'd love to chat with you!

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Bronze

Re: 2511 Remote access to additional routers via asynchronous li

I've seen this before and this article explains it clearly:

http://www.cisco.com/warp/public/793/access_dial/comm_server.html

HTH,

2 REPLIES
Hall of Fame Super Bronze

Re: 2511 Remote access to additional routers via asynchronous li

I've seen this before and this article explains it clearly:

http://www.cisco.com/warp/public/793/access_dial/comm_server.html

HTH,

New Member

Re: 2511 Remote access to additional routers via asynchronous li

EO,

Thank you for the reply. Had actually set a portion of this up this morning without checking back here for answers. The loopback interface is key. Eveything is up and running and I can telnet to all of the twelve routers currently hanging off of the asynchronous lines (octal cables) on the 2511. The article you provided has given me additional information which is greatly appreciated. Now to setup those menus for ease of use...

Thanks again,

Jason

575
Views
0
Helpful
2
Replies