Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2600 showing no interfaces

i loaded a 2610 xm with a c2600-c-mz.122-4.T1 and after booting it s not showing any of the onboard interfaces..

it was also showing an error on booting up If any of the above Memory Requirements are

"UNKNOWN", you may be using an unsupported

configuration or there is a software problem and

system operation may be compromised.

Rounded IOMEM up to: 4Mb.

2 REPLIES
New Member

Re: 2600 showing no interfaces

I think that is a wrong IOS, you are using a 2610"XM",

find a IOS can use for "XM"

Silver

Re: 2600 showing no interfaces

Are you sure that image is officially supported on the 2610XM. I have a feeling that it is not.

Also, unless any of the memory requirements state unknown, the above message is normal

129
Views
0
Helpful
2
Replies
CreatePlease login to create content