Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2610 XM problem

Hi all,

iam having 2610XM router on which i need to go to ROMMON mode but it is not taking ctrl+pausebreak is there any other solution even its not going ahead wait on ISAKMP OFF wat is the cause of this error.

1 REPLY
Bronze

Re: 2610 XM problem

Generally he router does not recognize the Ethernet ports, so recovery needs to be done from ROM Monitor (ROMmon) mode. Power cycle the router and press Ctrl+Break as it boots. The router goes to the ROMmon prompt. Router comes up in Rom mode after reload by power.

For instructions on loading the correct Cisco IOS Software version, http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bfac.shtml

117
Views
0
Helpful
1
Replies