So you want to do routing on a stick with a 10MBs connection with all those VLANs? Not sure, but you could run into performance/bandwidth issues shoving a lot of traffic down the 10MBs link. What are you trying to accomplish?
an nm-2fe-2w and an NM-1FE2W-V2 doesn't work in a 2600 (unless it's a 2691). read the info in the link that you posted under "Table 3. Maximum number of network modules that are supported in the 2600, 2691, 3600, 3700 and 3800 families is shown below.."
depends, how much traffic you're trying to pass down the single pipe. the router cpu itself will not have performance issues, it's the size of the pipe at 100MBs passing mulitple traffic between VLANs that you have to worry about. go ahead, set it up, and watch the bandwidth on the interface. if you are passing a lot of traffic back and forth between the VLANs, you're going to run into issues and should consider an L3 switch (like pete said above).
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...