You need to check two things since IOS version looks fine -
IOS feature set - You are running IP Base. The required feature set will be IP Voice or IP Plus.
DSPs - You need to have PVDM on the router for these cards to work. I guess 2600 router does not have a VIC slot. So you'll need a network module like NM-HDV2 on which you'll install the VWIC card and PVDMs.
For VWIC2-1MFT-T1/E1 you'll need a PVDM2-32 module.
I may be wrong in the slots suggestion since I didn't had a chance to work on 2600 router for long time, few years now and the suggestion is based on the information which I remember. Please cross check the same.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...