I have a 2611 with two ehternet (LAN) ports an 1ADSL Card and a 1ENET Wan Card
here's my version info IOS (tm) C2600 Software (C2600-I-M), Version 12.2(26), RELEASE SOFTWARE (fc2) Copyright (c) 1986-2004 by cisco Systems, Inc. Compiled Sat 31-Jul-04 04:57 by eaarmas Image text-base: 0x8000808C, data-base: 0x80A1E540
ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
DMGRouter0 uptime is 53 minutes System returned to ROM by power-on System image file is "flash:c2600-i-mz.122-26.bin"
cisco 2611 (MPC860) processor (revision 0x203) with 28672K/4096K bytes of memory. Processor board ID JAD05370KQ6 (2533697732) M860 processor: part number 0, mask 49 Bridging software. X.25 software, Version 3.0.0. 2 Ethernet/IEEE 802.3 interface(s) 32K bytes of non-volatile configuration memory. 16384K bytes of processor board System flash (Read/Write)
Here's my goal I'd like to do DHCP for two networks, a 10.3.xxx and a 192.168.xxx (one on each lan port) I'd like to use the dsl card to replace the Actiontec m1000 POS
The router isn't showing the WIC cards in config
I'd like to do port forwarding
I have a static IP from CentruryLink
I'm running several servers on the 10.3.xx and an access point, printers and such on the 192.168xx
I'd like to get rid of the Actiontec, and the wrt300 that's handling the 192.168.xx
I have a VLAN set up already for each network on a 2950..
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.