Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

2611 router bootup message error

Hi,

I need to convenice on of my customer that below message is cisco message or just bootup message& it is not memory problem.Please suggest

Smart Init is enabled

smart init is sizing iomem

ID MEMORY_REQ TYPE

000092 0X000B3280 C2600 Dual Ethernet

000021 0X000C7B00 Octal port S/T interface Multi-BRI

0X00098670 public buffer pools

0X00211000 public particle pools

TOTAL: 0X004243F0

If any of the above Memory Requirements are

"UNKNOWN", you may be using an unsupported

configuration or there is a software problem and

system operation may be compromised.

Rounded IOMEM up to: 5Mb.

Using 12 percent iomem. [5Mb/40Mb

Regards,

Moorthy

2 REPLIES

Re: 2611 router bootup message error

I'm not trying to be sarcastic but tell the customer to read the output.

'If any of the above Memory Requirements are

"UNKNOWN", you may be using an unsupported

configuration or there is a software problem and system operation may be compromised.'

There are no unknowns so you're OK. I would assume the numbers before the cards are where in memory the cards are reserving RAM.

Blue

Re: 2611 router bootup message error

this message is OK as shown above.

this is only an 'informational' message stating that if any of the above memory is 'unknown' then you may have an issue.

since you have no 'unknown' as it stands, this message is OK and you have no issues.

133
Views
0
Helpful
2
Replies
CreatePlease to create content