Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2612 - Vlan routing (sorry wrong forum)

I just recently bought a couple 2612s for a home lab. My intentions was to use one to route between VLANs. I can get into a subinterface of e0/0, but I cannot configure encapsulation. Can I create a VLAN interface on a 2612?

Thanks!

2 REPLIES

Re: 2612 - Vlan routing (sorry wrong forum)

Dear,

Check your IOS image.

Best Regards,

Mounir Mohamed

Re: 2612 - Vlan routing (sorry wrong forum)

At least with c2600-telco-mz.122-8.T10.bin IOS VLAN's are supported on 2610 (sorry, can't verify on 2612, but Eth is the same there):

CE-1#sh run interface ethernet 0/0.502

Building configuration...

Current configuration : 95 bytes

!

interface Ethernet0/0.502

encapsulation dot1Q 502

ip address 172.16.1.6 255.255.255.0

end

CE-1#ping 172.16.1.2

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 172.16.1.2, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/4 ms

126
Views
0
Helpful
2
Replies