08-14-2006 07:28 PM - edited 03-03-2019 01:39 PM
I just recently bought a couple 2612s for a home lab. My intentions was to use one to route between VLANs. I can get into a subinterface of e0/0, but I cannot configure encapsulation. Can I create a VLAN interface on a 2612?
Thanks!
08-15-2006 01:08 AM
Dear,
Check your IOS image.
Best Regards,
Mounir Mohamed
08-15-2006 03:00 AM
At least with c2600-telco-mz.122-8.T10.bin IOS VLAN's are supported on 2610 (sorry, can't verify on 2612, but Eth is the same there):
CE-1#sh run interface ethernet 0/0.502
Building configuration...
Current configuration : 95 bytes
!
interface Ethernet0/0.502
encapsulation dot1Q 502
ip address 172.16.1.6 255.255.255.0
end
CE-1#ping 172.16.1.2
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.16.1.2, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/4 ms
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: