Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

2620 and Cisco SDM

We are currently running c2600-is-mz.120-7.T2.bin on a 2620. We would like to use Cisco SDM to monitor the router.

We only have the following memory :-

libabb#sh vers

Cisco Internetwork Operating System Software

IOS (tm) C2600 Software (C2600-IS-M), Version 12.0(7)T2, RELEASE SOFTWARE (fc1)

TAC Support: http://www.cisco.com/tac

Copyright (c) 1986-2002 by cisco Systems, Inc.

Compiled Sun 10-Feb-02 00:28 by ccai

Image text-base: 0x80008088, data-base: 0x80C52A94

ROM: System Bootstrap, Version 12.1(3r)T2, RELEASE SOFTWARE (fc1)

libabb uptime is 21 weeks, 5 days, 9 hours, 53 minutes

System returned to ROM by power-on

System image file is "flash:c2600-is-mz.120-7.T2.bin"

cisco 2620 (MPC860) processor (revision 0x600) with 26624K/6144K bytes of memory

.

Processor board ID JAD05500NBS (231475022)

M860 processor: part number 0, mask 49

Bridging software.

X.25 software, Version 3.0.0.

1 FastEthernet/IEEE 802.3 interface(s)

1 Serial network interface(s)

32K bytes of non-volatile configuration memory.

8192K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102

libabb#dir

Directory of flash:/

1 -rw- 7331652 <no date> c2600-is-mz.120-7.T2.bin

8388608 bytes total (1056892 bytes free)

Can you please advise on a IOS version we should use, and if we need to upgrade the flash/ DRAM etc to run Cisco SDM.

Cheers

1 REPLY
Hall of Fame Super Bronze

Re: 2620 and Cisco SDM

SDM version 2.1 and later can be installed on a PC, no need to worry about the router's flash space.

However, SDM does not support non-XM 2600 routers - which is the model you are currently running.

Please check out its readme at:

http://ftp-sj.cisco.com/pub/web/sdm/SDMv2.4.1-Readme.html

834
Views
5
Helpful
1
Replies
CreatePlease to create content