Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2651 and the WIC-1DSU-T1-V2

I have put two WIC-1DSU-T1-V2 modules into my 2651 and I am not able to configure them. A 'show diag' command shows the modules, part number, serial number, etc. I ran this configuration through the software advisor and it claimed that I could use the V2 cards and gave me a couple of IOS images, which I loaded one. I have found one or two documents that say you can't use them. Does anyone know for sure whether or not the V2 cards will work in the 2651?

Thanks,

Jack

1 REPLY
New Member

Re: 2651 and the WIC-1DSU-T1-V2

WIC-1DSU-T1-V2 is only supported in 2600Xms or 2691.

207
Views
0
Helpful
1
Replies