Need help in placing all 6 ATM interfaces into one ima-group. The 2691 will only allow upto 4 vwics on AIM card, so I place 2 T1 controllers to the second AIM. When I goto place the last to intefaces into the ima-group I get the following error message: %AIM slot or Physical Type mismatch between AIM interface(s) and IMA group or existing IMA links, cannot add link.
I haven't been able to confirm this, but I believe you are not going to be able to span the IMA group over two AIM modules. If I can track down documentation on this, I'll post it here. If you really need that many links, you should look on eBay to purchase the 8-port IMA network module (NM-8T1-IMA).
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...