I have a 2800 router with two serial interfaces, for some reason the second serial showing the clock rate command. we tried to remove it with the "no" but it does not work.. Whenever we connect the serial cable to this interface, it shows as DCE not DTE (show controllers s0/0/1).. How can we fix that?
It might help to know what kind of interface this was (and what kind of controller). But in general the determination of DTE or DCE depends on the cable that is connected. Can you tell us about the cable and can you verify whether it is a DCE cable or a DTE cable?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.