Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

[2800 with NM-16ESW and 2 HWIC-1FE]

hi,

when trying to configure a 2811 with 3 ethernet modules, the dynamic configuration tool shows the following error:

Errors

1. Incorrect quantity of etherswitch modules (i.e. HWIC-ESW, NM-ESW) selected. Currently there are [3] ESW modules selected for [CISCO2811]. Please select between 0 and 2.

is there a restriction for the HW configuration on a 2811? can you please provide link to documentation?

regards,

c.

2 REPLIES

Re: [2800 with NM-16ESW and 2 HWIC-1FE]

New Member

Re: [2800 with NM-16ESW and 2 HWIC-1FE]

thanks, collin.

the thing here is that the DCT seems to have a restriction (or maybe the box itself). it won't allow you to 'configure' the box to have an NM-16ESW and 2 HWIC-1FE at the same time. maybe it's HW/SW possible, but the dynamic configuration tool won't allow me to.

334
Views
0
Helpful
2
Replies