Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2801 router loses a command line after reboot

Have you ever seen where a Cisco router "lose a command line and then will not accept a command line?

First of all, before rebooting a 2801 RTR I wrote the config and then rebooted the router.

After the reboot we started having incoming email issues. I checked the config and somehow it “lost” a line in the config.

So I put the line back in and wrote the config, again. Usually if a RTR doesn't like a command line it'll say something. but the rtr didn't say anything.

I then did a "sh run" and the line was gone!

Thoughts?

5 REPLIES
New Member

Re: 2801 router loses a command line after reboot

do you copy and past or enter the command manualy ?

Re: 2801 router loses a command line after reboot

What command are you typing/pasting?

New Member

Re: 2801 router loses a command line after reboot

i tried both ways....

i copied the line from a backup.

and i typed it in manually.

the line i'm trying to get into the RTR is:

ip nat inside source static tcp 10.30.47.5 25 66.140.170.131 25 extendable

Re: 2801 router loses a command line after reboot

Do you see it when you do "sh ip nat translation" ?

New Member

Re: 2801 router loses a command line after reboot

pages and pages of NAT translations.

which tells me it's working but why can't i see that line in the config?

153
Views
0
Helpful
5
Replies