We have open a division in the UK and are using DSL as a back up to a T1-E1, so I was going to use a standard DSL Modem but thought the WiC-1ADSL-I-DG would be better. However I can seem to get the card up and running. Here is the interface config and sh int atm.
ip address dhcp
ip access-group 102 in
ip inspect SDM_LOW out
ip nat inside
no atm ilmi-keepalive
dsl operating-mode auto
ATM0/1/0 is down, line protocol is down
Hardware is DSLSAR (with Alcatel ADSL Module)
Internet address will be negotiated using DHCP
That's part of the sh int amt.
Anyway I can't get the interface to function and I was looking for any help.
It was working for last 3 years, out of no where stopped working. Then i connected dlink wan router & checked that if modulation type is ADSL (multimode) it doesnt work. If it is ADSL2/ADSL2+ then it works. Service provider is taking lot of time to tell us exact modulation time.
I want to confirm that HWIC-1ADSL will work for above 2811+ IOS,, so i can buy & do it myself
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...