Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

2811 and ISDN configuration

Hello,

I have a new 2811 with an PRI ISDN card installed (NM-1CE1B=) and can not seem to enable and configure it. I have tried the usual commands:

card type e1...

controller e1...

...but neither are accepted. It wont even accept configuring ISDN switch-type global commands. It doesn't appear to accept any ISDN commands at all. I have tried 2 differenet IOS levels which both state they accept ISDN:

Cisco 2811

c2800nm-advipservicesk9-mz.124-3g.bin

c2800nm-adventerprisek9-mz.124-9.T.bin

Can anyone advise a level of IOS to use pleased?

rgds

Phil

2 REPLIES
Silver
New Member

Re: 2811 and ISDN configuration

Thanks for this link - looks like it's not supported.

Phil

291
Views
4
Helpful
2
Replies