Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

2811 and VWIC-1MFT-E1

i have a 2811 router with (C2800NM-ADVIPSERVICESK9-M), Version 12.4(15)T. I was intending to configure this E1 card for Data but it doesn't take me to the controller interface. what might be the problem? can this vwic do data?

  • WAN Routing and Switching
4 REPLIES
Silver

Re: 2811 and VWIC-1MFT-E1

Hi,

I think it does support data as well. What does the show diag show?

Krisztian

New Member

Re: 2811 and VWIC-1MFT-E1

Hi,

Configure the command -- card type E1

Regards

Santhosh M.C

Cable&Wireless

New Member

Re: 2811 and VWIC-1MFT-E1

Hi,

Try the following,

Router(config)# card type e1 subslot

Then,

Router(config)#controller E1 port

Go on to configure the controller as usual followed by your serial interface.

Cheers,

Hall of Fame Super Gold

Re: 2811 and VWIC-1MFT-E1

Actually, VWIC-xMFT-E1 does not need 'card type' command. Only the VWIC2 cards do need it.

513
Views
0
Helpful
4
Replies
This widget could not be displayed.