Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2811 - Flash (no device available)

Hi All

Just tried upgrading IOS on 2811 by putting CF card into reader on PC and copying IOS onto it.

PC reported CF needed formatting to use it so I formatted as FAT and copied IOS onto it.

Router boots up fine with new IOS image but a show flash command reports:

Router#show flash

%Error show flash: (No device available)

Any Ideas?

Thanks in advance

3 REPLIES
Hall of Fame Super Blue

Re: 2811 - Flash (no device available)

Hi

Have you tried just entering "dir" at the prompt to see where it thinks your image is.

Jon

New Member

Re: 2811 - Flash (no device available)

I used a different flash card (but did exactly the same procedure) but this one works! So I'm sticking with the non cisco CF.

Thanks anyway.

New Member

Re: 2811 - Flash (no device available)

try this commande : dir flash:

444
Views
0
Helpful
3
Replies
CreatePlease login to create content