Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

2811 getting lost cell delineation

I am installing some 2811 router with AIM-ATM-T1 interfaces. When I add the network-clock-participate wic 0, I get am ATM_AIM-5-cell_ALARM_DOWN and the ATM_AIM-5-cell_ALARM_up : Interface [chars] lost cell delineation message. I have check clocking settings and they are right. After moving the T1 and AIM cards around the message stop. This is happening on deferent IOS.

1 REPLY
New Member

Re: 2811 getting lost cell delineation

Hi Rich,

Can you please provide the configuration of the 2811?

The clocking configuration should look like the following if you're going to configure an IMA circuit:

network-clock-participate wic 0

network-clock-participate aim 0

network-clock-select 1 T1 0/0

network-clock-select 2 T1 0/1

If you're to configure individual ATM/T1 circuits then you don't need to participate the AIM module.

Let me know how it goes.

Regards,

Juan

163
Views
0
Helpful
1
Replies
CreatePlease to create content