cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
361
Views
0
Helpful
1
Replies

2811 getting lost cell delineation

richcampbell
Level 1
Level 1

I am installing some 2811 router with AIM-ATM-T1 interfaces. When I add the network-clock-participate wic 0, I get am ATM_AIM-5-cell_ALARM_DOWN and the ATM_AIM-5-cell_ALARM_up : Interface [chars] lost cell delineation message. I have check clocking settings and they are right. After moving the T1 and AIM cards around the message stop. This is happening on deferent IOS.

1 Reply 1

jcorrale
Level 1
Level 1

Hi Rich,

Can you please provide the configuration of the 2811?

The clocking configuration should look like the following if you're going to configure an IMA circuit:

network-clock-participate wic 0

network-clock-participate aim 0

network-clock-select 1 T1 0/0

network-clock-select 2 T1 0/1

If you're to configure individual ATM/T1 circuits then you don't need to participate the AIM module.

Let me know how it goes.

Regards,

Juan

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco