Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2811 port forwading?

our 2811 gets the internet from comcast static IP and communicates to other devices to our network via a T1.

I need to setup a port forward to allow traffic to a webcam insode the network, anything coming from outside (comcast)on port 80 and send it to 10.10.xxx.xxx

Not sure how to do this.

need helpd.

thank you.

Zeek

1 ACCEPTED SOLUTION

Accepted Solutions

Re: 2811 port forwading?

ip nat inside source tcp 10.10.xxx.xxx 80 80

Don't forget to allow it on your ACL too.

Hope that helps.

4 REPLIES

Re: 2811 port forwading?

ip nat inside source tcp 10.10.xxx.xxx 80 80

Don't forget to allow it on your ACL too.

Hope that helps.

New Member

Re: 2811 port forwading?

when i get to IP nat inside source ... i have to pick one of these:

list Specify access list describing local addresses

route-map Specify route-map

static Specify static local->global mapping

which one should i chooose?

New Member

Re: 2811 port forwading?

Done fixed.

Thank you

Re: 2811 port forwading?

Sorry, I was going off the top of my head :-)

115
Views
0
Helpful
4
Replies