We upgraded our infrastructure to Cisco 2811s and are now supporting voice services at our branch sites. Previously, the branch site routers didn't support QoS so we performed QoS based on anything originating from our Voice subnet 172.16.x.x. Our WAN provider is ATT MPLS service and ATT provides for 3 class of service categories as follows:
COS1 - Voice COS3 - Data COS4 - scavenger
I'm looking for best practice configuration guidance that would provide proper QoS on their 2811 routers at our branch sites. These Customer Equipment routers will then connect to the ATT Provider Equipment routers in ATT MPLS cloud.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...