Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

2811 Router questions ---- Router noob

If I add another T1 card into my 2811 to connect to an additional offsite location how would it be represented? Would it be Serial0/1/0:0?

Also if I added in an ethernet card into the 2811 can I have Ethernet 0/0 and 0/1 both going to the same switch and have both addressed to the same subnet?

Below is the snippit of my current T1 setup although I have changed the identifying info such as IP, DLCi and naming.

------------------------------------

!

interface Serial0/0/0:0

description Connection to nyctny MCI-C500-501

no ip address

no ip proxy-arp

encapsulation frame-relay IETF

load-interval 30

no fair-queue

frame-relay traffic-shaping

hold-queue 75 out

!

interface Serial0/0/0:0.500 point-to-point

description Connection to nyctny MCI-C500-501

bandwidth 1536

ip address 192.168.255.55 255.255.255.252

ip access-group serial0_0_0.500 in

no cdp enable

frame-relay class MCI_t1_t1

frame-relay interface-dlci 500

crypto map SecureMe

1 REPLY
Hall of Fame Super Bronze

Re: 2811 Router questions ---- Router noob

Yes, on the T1 query

No, on the LAN interface query. Both physical interfaces can't have overlapping subnets.

81
Views
4
Helpful
1
Replies