Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

2811 router

Can someone please tell me how to enable IP routing on a 2811 router? When I add the "IP CEF" command to the startup config, it'll ask me to enable ip routing first. Thank you!

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: 2811 router

Jose

Usually ip routing is enabled by default on 2811 routers (and on all routers). It sounds like someone may have disabled ip routing on your router. To enable it use the command:

ip routing

It is pretty simple. Give it a try and let us know how it works.

If it does not work then perhaps you could post the output of show protocol and the output of show run.

HTH

Rick

1 REPLY
Hall of Fame Super Gold

Re: 2811 router

Jose

Usually ip routing is enabled by default on 2811 routers (and on all routers). It sounds like someone may have disabled ip routing on your router. To enable it use the command:

ip routing

It is pretty simple. Give it a try and let us know how it works.

If it does not work then perhaps you could post the output of show protocol and the output of show run.

HTH

Rick

235
Views
0
Helpful
1
Replies
CreatePlease to create content