Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

2811 SDSL

hello all,

I'm not seeing the G.SHDSL card installed in a 2811 router. The output is

WIC Slot 0:

Unknown WAN daughter card

WIC module not supported/disabled in this slot

Hardware Revision : 0.0

Top Assy. Part Number : 800-26571-02

Board Revision : A0

Deviation Number : 0

Fab Version : 01

PCB Serial Number : FOC10312NJH

RMA Test History : 00

RMA Number : 0-0-0-0

RMA History : 00

The current IOS version:

Cisco IOS Software, 2800 Software (C2800NM-IPBASE-M), Version 12.4(3f), RELEASE

SOFTWARE (fc3)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2006 by Cisco Systems, Inc.

Compiled Fri 18-Aug-06 18:47 by alnguyen

ROM: System Bootstrap, Version 12.4(1r) [hqluong 1r], RELEASE SOFTWARE (fc1)

KingstonRouter uptime is 42 minutes

System returned to ROM by power-on

System image file is "flash:c2800nm-ipbase-mz.124-3f.bin"

Can anyone advise what the issue may be? Apologies if its basic, I'm a switch person not a router one :-)

Thanks in advance

Andy

andy_at_optimip_dot_net

2 REPLIES

Re: 2811 SDSL

Hi Andy

Please can you confirm the part code of the WIC? Are you trying to install the WIC-1SHDSL-V3. I know for this module that if you are running a 12.4 mainline image the minimum requirement is 12.4(3g), which would be one rebuild higher than your current release.

Please let me know.

Regards

Martin

New Member

Re: 2811 SDSL

hi Martin,

thanks for this will give it a go! Any other "gotchas" to be aware of? I'm unfortunately trying to configure it from the wrong (ie remote) end of an IP tunnelled console link so woudl prefer to make mistakes on this forum than on the router :)

Regards

Andy

141
Views
0
Helpful
2
Replies
CreatePlease to create content