I have a 2811 with a VWIC for support of data and voice transmission across the point to point T1 WAN to my Nortel BCM phone service (the other end is a 1801 with VWIC). My question is: i am having trouble finding the appropriate CLI commands for proper configuration of the VWIC to balance the data transmission (minimal 6 clients) and voice transmission (10 IP phones), provide appropriate encapsulation, and configure the QoS across this line. I also am concerened that the VWIC may not be enogh and i may need an add in module. Any help would be appreciated
I have a 2811 with a HWIC in slot 1 and a VWIC in slot 2, the VWIC has 2 ports.
In the the 2801 i have a VWIC with one port in slot 1. Its my understanding that this set up will work with the following senario:
2811 out the HWIC to T1 internet connection. One port in the VWIC to my point to point T1 onnection to the 2801 VWIC point to point connection. The 2811 provides the internet connection to the 2801 LAN and also the connection to my Nortel IP phone system.
Please advise if there is an issue or if you need more info into the setup. I have posted to the IP Phone End User forum about QoS in this setup with a reply in the affirmative from Brandon.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...