I am running a Cisco 2821 with a VWIC2-1MFT-E1/T1 card. When I enter the controller config I don't have the option to set the controller to unframed.
I have read through the on-line docs and the command I seem to be looking for is channel-group 0 unframed but that is not available as well the online docs reference that the 26xx and 36xx added that command. Perhaps my IOS doesn't support this command? or there is a different one used for the 28xx class?
Thanks to both of you for your responses it really helped. Would there be any degration in transfer rate if we added framming to our G.703 circuit provided by our telco? We wanted a full E1 2048Mbps line and I believe I did read some where that I would lose 64kbps if framing was enabled on this line.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.