Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

2821 router with dual ISP connection

I have ordered a 2821 router with the plan to keep my current T1 Internet connection and adding a 6MG Ethernet Internet connection. This router will be connected to an ASA device.

I want to be able to send all email traffic through my current T1 and send all other traffic through the other connection. I believe I can use policy based routing.

Has anyone previously done this and can give me some insight?

Thank you.

3 REPLIES

Re: 2821 router with dual ISP connection

hi...

i havnt configure such thing but you can tryit out...

for here you have to configure the accesslist wihich permit the SMTP port with any any configuration... and then you have to permit that SMTP accesslist in the route maps using the match list... and then you can set the nex hop option with the interface ip address to which T1 is connected...

hope this will help you

rate this post if it helps

regards

Devang

Silver

Re: 2821 router with dual ISP connection

In addition to Devang's post. Check below for the configuration guide.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1831/products_configuration_guide_chapter09186a00800c60d2.html

You have to ensure what port no. of the email traffic and apply the PBR to the correct incoming interface (e.g. LAN) and point to the correct outgoing (next-hop, i.e. remote IP address or the local interface name).

Hope this helps.

New Member

Re: 2821 router with dual ISP connection

Thanks to you both, I will check out the website and attempt to configure the router when it arrives.

-Dominick

186
Views
0
Helpful
3
Replies