07-30-2007 08:58 AM - edited 03-03-2019 06:05 PM
Ok, I have a 2821 router that has a username and password. I thought I knew what they were, but apparently not. I even get prompted for them in Rommon.
07-30-2007 09:13 AM
You can do a password recovery on the ISR.
Please use the link below for the procedure.
HTH,Please rate if it does.
-amit singh
07-30-2007 09:28 AM
I get to step 4 of this proceedure and I get the username and password prompt again. It never gets into ROMMON, so I can not input the commands in step 5.
07-30-2007 12:33 PM
Hi,
There is either one of 2 issues:
1. Either you are not able to do a break, and accordingly please check this doc:
http://www.cisco.com/en/US/products/hw/routers/ps133/products_tech_note09186a0080174a34.shtml
2. Service password-recovery is disabled, and if thus please check the following doc:
HTH,
Mohammed Mahmoud.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide