Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2851 doesn't allow E1 controller config

I have a new 2851 running IOS 12.4(22)YB1. It has a VIC3-2FXS/DID card in slot 0/0 and a VWIC2-1MFT-T1/E1 in slot 0/3. in the running config, I can see the config for the voice-ports, but nothing for the controller. When I run 'show controllers' I get the two GBit interfaces and the NME-CUE module in slot 1/0, but no T1/E1 card.

However, when I run 'show inventory' and 'show diag' I can see the entry for the controller.

Is there something that I'm missing here that will allow me to configure the E1 controller?

Thanks.

Stu

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: 2851 doesn't allow E1 controller config

card-type e1 0/3

2 REPLIES
Hall of Fame Super Gold

Re: 2851 doesn't allow E1 controller config

card-type e1 0/3

New Member

Re: 2851 doesn't allow E1 controller config

Fantastic!

Thanks, mate...

309
Views
5
Helpful
2
Replies