Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2900 poor management performance (ping & CLI)

Hello,

Has anyone seen a problem with models C2950C-24 and/or 2924M-XL-EN when pinging the management VLAN configured? I am seeing very high response times (above 400-500ms) and slow CLI performance even with very little load running across the primary uplink to the switch (100m uplink with <10k traffic).

There are no CRC or other errors on the link and other switches (diff models 3550/3750s) are performing much better (4/5ms) which are a hop (L2) or so away...

rgds

Phil

4 REPLIES
Bronze

Re: 2900 poor management performance (ping & CLI)

Hi,

issue a show proc cpu.

Regards,

Bjornarsb

New Member

Re: 2900 poor management performance (ping & CLI)

CPU more than acceptable:

CPU utilization for five seconds: 15%/6%; one minute: 11%; five minutes: 12%

New Member

Re: 2900 poor management performance (ping & CLI)

Hi,

Pls send across the sh vlan database & sh vlan command out put.

Is there any VTP server configured in the switching domain.

Regards,

New Member

Re: 2900 poor management performance (ping & CLI)

Hi,

Details attached of one affected switch. As a side point the switch details attached are for a switch that is connected via a different VTP domain, and via an access vlan connection (VLAN3) to another switch. Not ideal, but should still work.

Another switch I see the same problem with is connected via a trunk port to our core backbone switches, in the same VTP domain. Again, CPU around 15-20%, no errors or hardware issues seen, and bandwidth across the 100m uplnk very small (<10%).

thanks

Phil

128
Views
0
Helpful
4
Replies