Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

2911/WIC Issue

New 2911 running 15.1(1)T, base,sec and data licenses and new VWIC2-1MFT-T1/E1

Shows in the inventory but cant use serial interface  commands, not showing in sh run, tried in different slots. My first 2900 series router, am I missing something ??

bva-2911#sh inventory

NAME: "CISCO2911/K9 chassis", DESCR: "CISCO2911/K9 chassis"

PID: CISCO2911/K9      , VID: V01 , SN: xxxxxxxxx

NAME: "VWIC2-1MFT-T1/E1 - 1-Port RJ-48 Multiflex Trunk - T1/E1 on Slot 0 SubSlot 0", DESCR: "VWIC2-1MFT-T1/E1 - 1-Port RJ-48 Multiflex Trunk - T1/E1"

PID: VWIC2-1MFT-T1/E1  , VID: V01 , SN: xxxxxxxxxx

NAME: "C2911 AC Power Supply", DESCR: "C2911 AC Power Supply"

PID: PWR-2911-AC       , VID: V01 , SN: xxxxxxxxx

1 ACCEPTED SOLUTION

Accepted Solutions

Re: 2911/WIC Issue

You can't set the card up with the "card type" command?

card type t1

Then you can configure the controller with the controller commands.

HTH,

John

HTH, John *** Please rate all useful posts ***
1 REPLY

Re: 2911/WIC Issue

You can't set the card up with the "card type" command?

card type t1

Then you can configure the controller with the controller commands.

HTH,

John

HTH, John *** Please rate all useful posts ***
1273
Views
0
Helpful
1
Replies