Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

2921 slot layout

I have a 2921 at a remote site, that I'm trying to configure a T1 for (with my ITP).  I'm not at the site, so I'm trying to describe to the end user were the plug the T1 cable in.  The router tells me it's

 

NAME: "VWIC3-1MFT-T1/E1 - 1-Port RJ-48 Multiflex Trunk - T1/E1 on Slot 0 SubSlot 0", DESCR: "VWIC3-1MFT-T1/E1 - 1-Port RJ-48 Multiflex Trunk - T1/E1"
PID: VWIC3-1MFT-T1/E1  , VID: V01 , SN: FOC18351RNB

 

 

The Cisco drawing makes me think it'll be that top right shown as point 1?  Is that correct?

 

Also, when configuring the T1, it would be controller T1 0/0/0 ?

 

Thanks

Bill

 

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Hi Bill,VWIC slots 0,1,2, and

Hi Bill,

VWIC slots 0,1,2, and 3 (0, Far right)

As you are configuring the T1, did you configured the card to use the T1 port as Serial0. If no, please use this:

card type t1 0 0

controller T1 0/0/0

framing esf

linecode b8zs

cablelength long 0db

channel-group 0 timeslots 1-24

-------

 

BR// Sanjay

1 REPLY
New Member

Hi Bill,VWIC slots 0,1,2, and

Hi Bill,

VWIC slots 0,1,2, and 3 (0, Far right)

As you are configuring the T1, did you configured the card to use the T1 port as Serial0. If no, please use this:

card type t1 0 0

controller T1 0/0/0

framing esf

linecode b8zs

cablelength long 0db

channel-group 0 timeslots 1-24

-------

 

BR// Sanjay

150
Views
0
Helpful
1
Replies