Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

2950 SW enhanced/standard image difference

i don't want to know the all differences, i just want to be sure that the vlans will work:

so, i have a customer that have a 2950 with enhanced image, and he had layer2 vlans, and now he buy 2 more 2950 SWs but with standard image, and i want to connect then with trunk and make the same layer2 vlans with vtp, and thats all.

is there any differnce with layer2 vlans between standard/enhanced image?

pls do not bring me a link to the differnce page, cause i saw that allready, i want to be sure about that point specifically.

thanks a lot

  • WAN Routing and Switching
1 REPLY

Re: 2950 SW enhanced/standard image difference

Hi Amir,

No as such there no difference on how the vlan works on Standard image 2950 and Enhanced image. But there is a differece on the number of vlans supported. SMI 2950 supports around 64 vlans while EMI 2950 supports 250 vlans. There are a lots of other feature diffrences as well. Please see the datasheet for both the switch models and have the diffrence with you.

2950 with Standard Image

http://www.cisco.com/en/US/products/hw/switches/ps628/products_data_sheet09186a00801cfb71.html

2950 with Enhanced Image

http://www.cisco.com/en/US/products/hw/switches/ps628/products_data_sheet09186a00801cfb64.html

HTH, Please rate if it does.

-amit singh

253
Views
0
Helpful
1
Replies