I have a 2620 here with WIC-1DSU-T1 and WIC-1ADSL connected to the same ISP. T1 and DSL interfaces are on the same WAN e.g. public IPs X.Y.Z.10 (T1) and X.Y.Z.20 (DSL). Gateway is X.Y.Z.1 for both (T1&DSL), net is /24. What is the proper config for the 2620 to handle main traffic through the T1 and policy route HTTP(S) and FTP using the (faster) DSL line? How do I set up fallback to T1 if DSL is unavailable? Any help is very much appreciated!
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...