09-15-2007 07:35 AM - edited 03-03-2019 06:46 PM
Hallo Everybody
My first ME switch and I can not access it over ip
just because it needs a fancy config ?
The only access I can have is over console.
What ever I make it seems not to work
(simple vlan configuration:
Configure switch on a Vlan , then assign one port as switchport access for that vlan ,
and then try to connect to the 3400 but it fails. Not even ping operates. )
What is the problem with this device?
best regards,
09-15-2007 09:30 AM
Config please ?
09-17-2007 12:33 PM
Thank you for your response
ME3400#sh running-config
Building configuration...
Current configuration : 912 bytes
!
version 12.2
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname ME3400
!
enable secret xxx
!
username x password 0 123
no aaa new-model
system mtu routing 1500
ip subnet-zero
!
no file verify auto
!
spanning-tree mode rapid-pvst
spanning-tree extend system-id
!
!
!
vlan internal allocation policy ascending
!
vlan 4
name new_vlan
!
vlan 10
name **connect_to_3400_vlan
!
interface GigabitEthernet0/1
switchport access vlan 10
media-type rj45
!
interface GigabitEthernet0/2
shutdown
!
interface GigabitEthernet0/3
port-type nni
!
interface GigabitEthernet0/4
port-type nni
!
interface Vlan1
no ip address
no ip route-cache
!
interface Vlan10
ip address 10.10.10.10 255.255.255.0
no ip route-cache
!
no ip http server
!
control-plane
!
!
line con 0
line vty 0 4
login local
line vty 5 15
login
!
end
ME3400#
Vlan 10 is up/up , I connect in port gi0/1
rj45 pc with same network as vlan 10,
a) cannot ping
b) cannont telnet to the switch
Regards,
09-21-2007 02:42 PM
I believe you'll need to change the port-type on the g0/1 interface to nni (default comes as uni):
conf t
int g0/1
port-type nni
end
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: