Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

3640 Router - sh isdn

Hi,

We have a 3640 with an E1 Pri in slot 0 and a dual fast ethernet in slot 1, running 12.2.23.

The problem is that there is no "sh isdn" or "debug q931" .

We have the controller configured, the serial interface configured and cannot see what we are doing wrong.

Anybody have any idea's ?

Scott

7 REPLIES
Hall of Fame Super Gold

Re: 3640 Router - sh isdn

Show ver and show diag please ?

New Member

Re: 3640 Router - sh isdn

Hi

Sh ver & Sh diag attached.

Scott

Hall of Fame Super Silver

Re: 3640 Router - sh isdn

Scott

The first possibility that I would consider is that the router is not properly recognizing the card. Perhaps you could post the output of show version and perhaps of show diag and this might verify what the router thinks it has got.

Secondly is the possibility of some configuration issue. Perhaps you can also post the configuration of the router?

HTH

Rick

New Member

Re: 3640 Router - sh isdn

Hi

Sh run (with the company specifc stuff left out)

Hall of Fame Super Silver

Re: 3640 Router - sh isdn

Scott

Thanks for posting the additional information that we requested. I had hoped that it would clearly identify what card this was. But the closest I get is the identification of FRU Part Number WIC/VIC-E1=. And that does not tell me precisely what card it is. I am assuming that you have a E1 Multiflex Trunk Voice/WAN card.

In controller configuration mode is there an option to configure pri-group instead of configuring channel-group?

Also can you tell us any more specifically what card this is?

HTH

Rick

New Member

Re: 3640 Router - sh isdn

Hi Rick,

Can do but wont be until tomorrow now .

Hall of Fame Super Gold

Re: 3640 Router - sh isdn

Hi, you can't do isdn pri with that hardware. You need an nm-1ce1t1 that will allow you to configure pri-group.

185
Views
0
Helpful
7
Replies
CreatePlease to create content