01-05-2007 02:57 PM - edited 03-03-2019 03:16 PM
Can anyone provide assistance on how to configure a 3640 with a HSSI card to talk to a Kentrox CSU/DSU for a fractional T3?
I have the info on the Kentrox as:
Kentrox: DSUCLK:3.0,3.0
For a 3Mb frac.
Thanks
Solved! Go to Solution.
01-11-2007 11:34 AM
Here's a config example for you.
interface Hssi1/1
description HSSI to NYC3725-2 H1/0
bandwidth 30709
ip address 10.254.253.2 255.255.255.252
ip pim sparse-dense-mode
serial restart-delay 0
hold-queue 250 out
You'll want to change the bandwidth statement and remove PIM. The config is staight forward.
HTH and please rate.
01-11-2007 11:08 AM
Cisco BRI network module (use one of the following):
NM-4B-S/T - Four-port ISDN BRI network module, minimum version 800-01236-03
NM-4B-U - Four-port ISDN BRI with integrated NT-1 network module, minimum version 800-01238-06
NM-8B-S/T - Eight-port ISDN BRI network module, minimum version 800-01237-03
NM-8B-U - Eight-port ISDN BRI with integrated NT-1 network module, minimum version 800-01239-0
http://www.cisco.com/en/US/tech/tk801/tk379/technologies_configuration_example09186a0080093c6e.shtml
01-11-2007 11:34 AM
Here's a config example for you.
interface Hssi1/1
description HSSI to NYC3725-2 H1/0
bandwidth 30709
ip address 10.254.253.2 255.255.255.252
ip pim sparse-dense-mode
serial restart-delay 0
hold-queue 250 out
You'll want to change the bandwidth statement and remove PIM. The config is staight forward.
HTH and please rate.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: