Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

3745 problem

I have a 3745 that crashed (it came back up but it looks like its only seeing one of its two AIMs

I have the crashinfo file it created if that might help

it has 2 aim-vpn/hpII's


Re: 3745 problem

any help would be welcomed

it crashed while I was correcting the config (just swapped it into the place of a 2651 and was turning on interfaces I had shutdown and ensureing proper config)

Re: 3745 problem

can someone offer assistance

Re: 3745 problem

since the aim1 light has been amber I figured it might be the problem so I swaped it for another one

but the light is still amber

is there something I need to do to enable it or something?

Re: 3745 problem


Looking at your crash file this is the log error that caused the crash.

%ALIGN-1-FATAL: Illegal access to a low address 19:02:20 -0500 Thu Oct 16 2008

addr=0x8, pc=0x63531608 , ra=0x635315F4 , sp=0x68936BE8

%ALIGN-1-FATAL: Illegal access to a low address 19:02:21 -0500 Thu Oct 16 2008

addr=0x8, pc=0x63531608 , ra=0x635315F4 , sp=0x68936BE8

Here is the output from the Error Message Decoder:

%ALIGN-1-FATAL: Illegal access to a low address

An alignment error has occurred. Alignment errors are caused by misaligned reads and writes. For example, a two-byte read of a memory address that is not a multiple of two bytes is an alignment error. Alignment errors are c aused by internal software failures. The system will be reloaded, often with a bus error.

Recommended Action: This message is caused by a software failure. To take advantage of recent fixes, upgrade your system to the latest Cisco IOS software release in your release train. If this message recurs, copy the error message text exactly as it appears on the console or in the system log, enter the show log, show alignment and show tech-support commands, contact your Cisco technical support representative, and provide the representative with the gathered information.



Re: 3745 problem


so it sounds like an IOS issue