Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3750 config register 0XF

Hi

what the purpose of having the register set to 0xf in the 3750 ?

i have a situation where it its booting in bootstrap, and i think this is causing it each time.

anyone know the reason behind that, and if i shoulod set it to 0x2 ?

thanks

2 ACCEPTED SOLUTIONS

Accepted Solutions
Cisco Employee

Re: 3750 config register 0XF

Hello Jafar,

As Joe has pointed out very correctly, the value 0xF is a correct configuration register value for a switch. In fact, I haven't seen a 29x0 or 3xx0 switch having a different configuration register value and I even have a feeling that the entire configuration register is there just for compatility with the common IOS code base and it is ignored completely.

Please, if possible, post here the transcript of the booting progress of that switch. We might be able to help you better.

Best regards,

Peter

Cisco Employee

Re: 3750 config register 0XF

This looks fine. I see no reason why the switch wouldn't boot directly to the 12.2(35)SE image on flash. As was statement previously, it would help to see the console output from the switch booting up.

6 REPLIES
Cisco Employee

Re: 3750 config register 0XF

No, 0xF is the proper value for this device. What is the output of "show boot" from this switch?

Cisco Employee

Re: 3750 config register 0XF

Hello Jafar,

As Joe has pointed out very correctly, the value 0xF is a correct configuration register value for a switch. In fact, I haven't seen a 29x0 or 3xx0 switch having a different configuration register value and I even have a feeling that the entire configuration register is there just for compatility with the common IOS code base and it is ignored completely.

Please, if possible, post here the transcript of the booting progress of that switch. We might be able to help you better.

Best regards,

Peter

New Member

Re: 3750 config register 0XF

thanks,

as350057s02#sh boot

BOOT path-list : flash:c3750-ipservices-mz.122-35.SE5/c3750-ipservices-mz.122-35.SE5.bin

Config file : flash:/config.text

Private Config file : flash:/private-config.text

Enable Break : no

Manual Boot : no

HELPER path-list :

Auto upgrade : yes

Auto upgrade path :

as350057s02#

New Member

Re: 3750 config register 0XF

i have the wrong stement there,

this is my issue,

still would like to know the reason behind 0xf, compared to other cisco devices.

thanks

Cisco Employee

Re: 3750 config register 0XF

The config register on the 3750 (and other desktop switches) is fixed at 0xF. It cannot be changed, but it is analogous to 0x2102 on other platforms in that it causes the switch to boot from flash, and load the saved config.text.

Cisco Employee

Re: 3750 config register 0XF

This looks fine. I see no reason why the switch wouldn't boot directly to the 12.2(35)SE image on flash. As was statement previously, it would help to see the console output from the switch booting up.

43439
Views
15
Helpful
6
Replies