I have a stack of 3750E (2 switches) and need to upgrade the software image. I understand that I generate the licence file using the PUK code however i am wondering when i load the licence file will it unlock both the master and the slave in the stack? Do i have to break the stack and upgrade each switch individually?
I've just done a few of these, you need 2 licences,if you still want your stack to run ipservices if the master fails. The license is tied to the serial number of the switch, you will need to copy the master license to flash: and slave license to flash2: then install by using the "licence install flash:filename" and "license install flash2:filename" commands. Confirm all is OK by using "show license detail" command then reboot to take effect.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...