Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

3750E switch install IOS issue

Hello,

I have an existing stack of 3750s all non-E series. I am trying to install a new 3750E (with ten gig uplinks). The new switch comes preloaded with a universal IOS with IPBase feature set, and the existing stack uses an IPBase feature set as well. However, I still get version mismatch between the switches:

existing IOS: c3750-ipbase-mz.122-40.SE.bin

3750E IOS: c3750e-universalk9-mz.122-35.SE5.bin (IPBase feature set)

Switch#sh license det sw 1

Index: 1 Feature: ipbase Version: 1.0

License Type: Permanent

License State: Active, In Use

Switch#sh sw det

Switch/Stack Mac Address :

H/W Current

Switch# Role Mac Address Priority Version State

----------------------------------------------------------

*1 Master 001e.xxxxxxxx 1 1 Ready

2 Member 001b.xxxxxxxx 1 2 Version Mismatch

Can anyone advise what IOS I should be using to get these speaking to each other?

thanks

Phil

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Bronze

Re: 3750E switch install IOS issue

You need to download the 3750e image (12.2(40)) manually since you won't be able to sync the image from a 3750 switch (different software).

For more information on inter-operating 3750E with 3750 in a stack, see:

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750e_3560e/software/release/12.2_35_se2/configuration/guide/swstack.html#wp1189523

HTH,

__

Edison.

3 REPLIES
Hall of Fame Super Bronze

Re: 3750E switch install IOS issue

You need to download the 3750e image (12.2(40)) manually since you won't be able to sync the image from a 3750 switch (different software).

For more information on inter-operating 3750E with 3750 in a stack, see:

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750e_3560e/software/release/12.2_35_se2/configuration/guide/swstack.html#wp1189523

HTH,

__

Edison.

New Member

Re: 3750E switch install IOS issue

Hello,

Thanks for the post - however, I thought the IOS release could differ between 3750 and 3750E so long as the feature set was the same:

"• Version mismatch-StackWise Plus requires switch members of the stack to have similar Cisco IOS® Software image types or feature set licenses. That is, if the master runs the IP Services feature set, then all members are expected to have the same type of Cisco IOS Software feature set, although the release level can be different. If this condition is not met, then the stack will go into a version mismatch mode."

I'll give you suggestion a go in the meantime.

thanks

Phil

Hall of Fame Super Bronze

Re: 3750E switch install IOS issue

The "base feature set" on the 3750E is higher than the "base feature set" on the 3750. Based on the file name, the 3750E "base feature set" you have comes with security features such as SSH as denoted by the 'k9' in the filename.

The paragraph you posted would apply if you were to have a 3750E with a 3750E "base feature set" or a 3750 with a 3750 "base feature set". Mixing the hardware along with different feature set won't apply.

__

Edison.

414
Views
0
Helpful
3
Replies